# Introduction to Mechanics of Materials: Part I

Valoración:
( 108 )
174 pages
Idioma:
English
This book is a pilot course in the Mechanics of Materials (Elasticity and Strength) offered to engineering students throughout the bachelor study.
eBooks más recientes
Sobre el autor

Assoc. Prof. Roland Jančo, Ph.D. ING-PAED IGIP

Roland Jančo studied in the area of Applied Mechanics at the Slovak University of Technology in Bratislava. He obtained his Ph.D. in 2003 and became an Assoc. Prof. in the area of Applied Mechanics in 2011.

Currently he is an Assoc. Prof

Assoc. Prof. Roland Jančo, Ph.D. ING-PAED IGIP

Roland Jančo studied in the area of Applied Mechanics at the Slovak University of Technology in Bratislava. He obtained his Ph.D. in 2003 and became an Assoc. Prof. in the area of Applied Mechanics in 2011.

Currently he is an Assoc. Prof

Descripción
Contenido
Opiniones

This book is a pilot course in the Mechanics of Materials (Elasticity and Strength) offered to engineering students throughout the bachelor study. The main objective of this course is for students of engineering to develop the ability to analyse a given problem in a simple and logical manner and to its solution, apply a few fundamental and well-understood principles. This book consists of 6 chapters which include fundamental types of loading: axial, torsional, bending, and transversal. Each chapter contains many solved and unsolved problems.

List Of Symbols

Preface

1. Introduction – Concept of stress
1. Introduction
2. A Short Review of the Methods of Statics
3. Definition of the Stresses in the Member of a Structure
4. Basic Stresses (Axial, Normal, Shearing and Bearing stress)
5. Application to the Analysis and Design of Simple Structures
6. Method of Problem Solution and Numerical Accuracy
8. Design Considerations and Factor of Safety
1. Introduction
3. Stress-Strain Diagram, Hooke’s Law, and Modulus of Elasticity
4. Poisson’s Ratio
6. Saint Venant’s Principle
7. Deformations of Axially Loaded Members
8. Problems Involving Temperature Changes
9. Trusses
10. Examples, Solved and Unsolved Problems
3. Torsion
1. Introduction
2. Deformation in a Circular Shaft
3. Stress in the Elastic Region
4. Angle of Twist in the Elastic Region
5. Statically indeterminate Shafts
6. Design of Transmission Shafts
7. Torsion of Non-Circular Members
8. Thin-Walled hollow Members
9. Examples, Solved and Unsolved Problems

Appendix

References

Es un excelente libro para aprender y reforzar lo aprendido...
it gives the basic idea towards material identification